操作过程：
    1、插上电源，打开电源总开关，电源指示灯随即着亮；（注意：整机必须有合适牢靠的保护地线）；将恒温器调较至所需温度（通常为130℃-200℃，如AAA级环保料烫膜温度一般为130℃-160℃）；将定时器调较至所需时间（通常为5至20秒左右）；
    2、当发热板温度上温到指定温度时先在发热板平铺3到5层热熔膜（按膜的厚度而定），注意铺平最好不要有气泡；
    3、将绣好的绣品有膜的一边平铺发热板上，注意铺平；
    4、手动压下压力手柄，等到时间倒数到“0”时拉上压力手柄；
    5、取下绣品即可（如果还有部分烫剥不干净可重复第3第4步）。

Operation process:
    1. Plug in the power supply, turn on the main power switch, and the power indicator light will be on; (Note: the whole machine must have a suitable protective ground wire); adjust the thermostat to the required temperature (usually 130 °C-200 °C) For example, the AAA grade environmentally friendly material film temperature is generally 130 ° C -160 ° C); adjust the timer to the required time (usually about 5 to 20 seconds);
    2. When the temperature of the heating plate reaches the specified temperature, firstly spread 3 to 5 layers of hot melt film on the heating plate (depending on the thickness of the film), it is best not to have bubbles when laying the flat;
    3, the embroidered embroidery has a film on one side of the flat heating plate, pay attention to flatten;
    4. Manually press down the pressure handle and wait until the time counts down to “0” to pull the pressure handle;
    5, remove the embroidery (if there is still some hot peeling is not clean can repeat the third step 4).